Plug and play voltage stabiliser on ISO power cable

For use when fitting an aftermarket radio in cars with automatic engine 'Start/Stop' technology.

For cars that have a drop in voltage on both ignition and permanent feeds during the engine cranking during the start/stop cycle causing the radio to turn off.

Tyco 12 Volt 30 Amp automotive 5 pin relay

Universal fit, multipupose.

RECOIL 6 Pack Relay kit (5-pin 30/40A 12V SPDT relays with sockets and in-line ATC fuse holders)

Bosch style 12VDC (14V Max) 5-Pin SPDT (Single Pole Double Throw) relay with 40A/30A high switching capability.

Relay kit Includes:

• 6 x relays
• 6 x relay sockets with wires
• 6 x in-line ATC fuse holders

RECOIL 10 Amp/ 12V DC Smart Accessory Power Provider  

• Provides 12-volts DC output when voltage is at or above 13.5-volts DC
• Designed for vehicles that do not provide accessory (switched) power
• 10-amp fuse included for safety
• Provides accessory power (13.5-volts 10-amps)
• Delayed Turn-off after vehicle has been turned off
• Universal Compatibility

For filtering 12 volt car audio products that have induced noise from alternators and other ignition sources

10 AMP

For filtering 12 volt car audio products that have induced noise from alternators and other ignition sources

30 AMP

For Filtering 12 Volt Car Audio Products That Have Induced Noise From Alternators And Other Ignition Sources.

This power relay cable is to be used when installing a camera into a vehicle.

Sometimes a reverse power feed from a reverse light may not be strong enough to power a camera or may create interference.

This relay can use a weak reverse trigger to switch on a better 12v power feed for a camera or reduce interference.

Requires hardwiring.

Drops 12V DC to 6V DC to provide a suitable power supply to a cars original parking camera.

Use with camera retention interfaces that do not have a voltage dropper built in.

PLEASE NOTE: This is not a camera interface. If you are looking to add or retain a camera please visit our car specific camera interface range

Recoil 2 Channel 80W adjustable high-to-low level subwoofer amplifier Line Output Converter (LOC) with a built-in amplifier remote trigger. This device is designed to convert 2 channels of speaker level audio into 2 channels of line level audio that can be used by car audio amplifiers.

This interface detects an audio signal and generates an amplifier turn on signal based on this, the amplifier turn on signal stays on for 60 seconds after the audio signal disappears. This allows the amplifier to stay turned on between tracks and during moments of silent audio.

RECOIL Universal amplifier level remote controller with Built-in Digital Voltmeter, Blue LED Display, Remote Gain Control and On/Off Switch.

• Dash-mount amplifier level control for volume adjustment
• Adjust the bass level even while driving
• In-dash or Under-dash mountable
• Compatible with most head units/amplifiers combinations
• Rotary push turn ON/OFF switch for a voltmeter (10V ~ 15.9V)
• Blue LED display (high voltage / low voltage)

Momentary panel mount rocker switch. Push and hold to activate the switch, springs back to original position on release. 19mm hole diameter.

ON/OFF panel mount toggle rocker switch. 19mm hole diameter.

5 Pin Relay Holder (12v 80amp)

Terminates in bare wires, approximately 300mm in length and 12awg.